
On 21 January it was finally time for the classic road bike show in Dessel, Belgium. The previous year I had gone as a visitor. This time we planned to have a small stall of our own. The days before a show are always a little hectic while you decide what to take and pack everything carefully. I had to make some more Cobalto nuts because they were nearly sold out. The excitement had started days before, especially the thought of what treasures we might find.
As usual, everything was finished at the last minute and packed into the car the evening before. At my first shows I took far too much stock. Now I take a selection of things visitors might like to see in person, such as the gold-plated parts or Cobalto nuts. We left for Belgium at five in the morning to arrive around seven. It is usually a longer drive from Germany because we do not have comparable events there. It is worth it for the chance to see our friends in Belgium or the Netherlands.
After two uneventful hours on the road we arrived among the first. Parking right outside the hall makes it easy to unload what you bring and load up the treasures you find. The organisers were friendly as ever and showed us straight to our table.
It is funny how quickly you switch into buying mode and catch a bit of gold fever at these shows, even when you are there to sell. I joined the other sellers rushing from table to table and checking out each part as it was unpacked.
Unlike the previous year, only one of the three side rooms and the outdoor area was used. The stage was opened up for stalls because the vintage jersey seller who normally uses it had fallen ill and had to cancel at short notice. We wish him a speedy recovery.
Once we had set up and taken a first look around, the time flew. Suddenly it was ten and the visitors were coming in. The hall filled straight away. The organisers had clearly done a fine job getting the word out, and Dessel is already well known and well attended among classic cycling enthusiasts. It shows how much interest there still is in classic road bikes and parts.
The visitors and other exhibitors were friendly as ever, and I thoroughly enjoyed the conversations. I also found a treasure of my own: a Peugeot Perthus Pro in Reynolds 753, in good condition with some Mavic parts, a matching jersey and a 56 cm frame I could ride. On the way home I planned to film the disassembly and the complete rebuild. In the end I stripped it down that very night. I could not wait! 🙂
I also bought some Campagnolo rear derailleurs and brakes. Every time I go to a show, I try to remember what I need and often write it down. Then I get there, the list disappears and I forget what I meant to buy. It all comes back to me on the drive home, and then I find the list in my trouser pocket. Every time! 🙂
All in all, it was a lovely show and we went home happy. Everything was well organised from booking to departure, and we would like to thank the organisers. We will be back next year.
To finish, here are photos from the beginning and end of the show. I had planned to take more photos and even make a video, but I was too busy looking for treasures!




































































As an update, here are a few photos of the things I bought. I have already stripped the bike and given it an initial clean. The longer I look at it, the more I like it. 🙂
I particularly like the triple Starfish crankset and the Mavic pedals.

























Pingback: Peugeot Perthus Pro in Reynolds 753 – VeloDeluxe – Classic Road Bikes and Parts