
A few months ago I bought a Martelly Super Competition frameset at a cycling swap meet in Belgium. Its colours caught my eye at once. The frameset has a Cinelli spoiler bottom bracket shell and many other fine details.
Before starting the build, I gave the frame a thorough clean, including the areas that would be hidden later. I used a brush and cleaner to reach the corners.
The bottom bracket area usually takes the most work. Old, hardened grease collects inside, while chain grease and dirt build up on the outside.
Once all the dirt is gone, you can inspect the inside of the tubes for damage such as rust. This one looked very good.
The cleaned frameset looked so good I wanted to start building straight away, but the components still needed work. I chose Campagnolo Nuovo Record again and planned to machine the seatpost, stem and crankset, as on the Vitus. I would flute parts of the crankset and cut recesses into the stem and seatpost, then add colour to match the bike. The brake levers and rear derailleur would also receive machined details.
The headset needed no modification. The photo shows the Campagnolo Nuovo Record headset being pressed into the head tube with fresh grease and a headset press. That also secures the fork in the frame.
I fitted the ball bearings with fresh grease.
Here is the installed headset. Correct seating in the head tube, adequate grease and proper adjustment are important for a long service life.
Once the parts had been machined and polished, the build could begin. I matched the components to the blue and yellow colour scheme. Yellow Benotto bar tape looked just right for this frame.
I chose silver Campagnolo rims with high-flange Record hubs and fitted a pair of new-old-stock Continental Sport tyres. Their light sidewalls suit a classic like this. The saddle is a black leather Concor.
The photo shows the bottom bracket, crankset and front derailleur installed. I fluted the crank arm and the arms of the spider, polished the entire crankset to a mirror finish, drilled the chainrings and chamfered the holes.
Here the 3ttt stem and handlebar are in place. I polished the stem and machined three recesses, then filled them with colour. Wrapping Benotto tape neatly takes practice. I wrapped the tape around the brake lever clamps before fitting the levers themselves.
I stripped and cleaned the rear derailleur and milled a lengthwise detail into the front plate, leaving the brand and model legible. I replaced the old jockey wheels as well.
I assembled the bike step by step. New housings, cables, tyres, tubes and a chain brought it back to near-new condition. I also colour-matched the mirror-polished brake callipers.
The pedals are Campagnolo Superleggeri with toe clips. The black Campagnolo brake hoods are new.
Here is the finished bike:























At the time of writing, the bike had been complete for several weeks. I planned to list it in the shop with more information and photos, and might still add a few details. It is already a striking one-off.
I also filmed the finished bike so you can see it in motion. As the video shows, I replaced the decorative Cobalto stones on the brake callipers with a set that suited them better: