
Some time ago I had the chance to buy a Gudereit road bike made in Bielefeld, Germany. Today many people associate Gudereit road bikes with budget models that look little like racing bikes. This one is different. The Reynolds tubing and complete Shimano 105 groupset make it a fine mid-range classic. Its condition also drew me in. About three years earlier I had owned the same model in another size and knew how good the paint would look once cleaned and polished. That is how this project began.
The bike was very dusty and the old grease had hardened. Having bought plenty of road bikes before, I could see there was a lovely machine under the dust. I checked for crash damage, rust and dents before taking it home.
First I stripped the bike down completely and removed the cables and bar tape. Then I laid everything out and filmed the bike and all its parts. A correction to the video: this is a 53.5 cm frame, measured centre to top, from the middle of the bottom bracket to the top of the seat tube.
Once the bike was apart, the frame and components proved to be in very good condition, as I had expected. They still needed work because of the dust and hardened grease. I had seen how the bike was stored: it had spent at least 20 years in a warm, bone-dry cellar. The grease in the bottom bracket, headset and chain had dried and hardened completely.
According to the previous owner, the bike was bought new in the 1980s and last ridden in the 1990s. That fits its condition and would put its time in the boiler room at as much as 30 years.
First I cleaned the parts with WD-40.

I sprayed everything to loosen the screws before disassembly.

The bottom bracket with its hardened grease still in place.

The bottom bracket after cleaning.

Cleaning the front derailleur. You can see the old grease from the front and rear derailleurs dissolving in the tray, although in the video above both parts only looked a little dusty.

I used polishing compound to bring the rims to a mirror shine. My fingers paid for it that evening, but the rims looked great.
Once all the parts had been checked, cleaned and polished, I filmed everything again before starting the rebuild.
Then came my favourite part. However many bikes I have built, I still look forward to putting one back together and seeing it at its best, clean, polished and gleaming. It is the reward for many hours of work.
Here is a video of the almost finished bike.
I was very pleased with the finished bike. It turned out just as I had pictured it when I bought it. It was due to be listed in the shop and on eBay in the following days, and I hope its new owner gets plenty of enjoyment from it.


















